Categories

Contact Us

Wuxi Green Lawn Co.,Ltd
Add:Room 1001-1004, Lian Dong U Gu Business Zone, Fengbin Road, Beitang District, Wuxi, Jiangsu, China
Tel:+86-510-83709982
Fax:+86-510-83118116
Ph:+8618961721602
E-mail:greenlawn@green-lawn.cn

Artificial grass installation

- Nov 29, 2017 -


1.1. Inspection of artificial grass carpet:

Inspect the foundation to ensure it has a flat and smooth surface and appropriate slopes,making sure the

foundation is qualified for installing artificial turf;


1.2. Measuring: 

Locate the centers of the ground and the two semicircles, and according to these three centers locate the

intersecting point of half-way lines and touchlines, and then determine the positions of functional lines

and spot by using Pythagorean proposition;


2. Turf layout: 

According to drawing, position the artificial turf rolls on the exact places along the touchline.The turf with white

lines should be placed at the half-way lines and base line, and then lay out the rolls in order;

3. Preparing functional line: 

Cut white turf piece into strips(width to be as per actual need) for white functional lines(half-way lines,

base lines etc.), and put them aside preparing for Green Artificial Grass Carpet installation;


4. Seaming: 

The adiacent turf rolls must be join together with 20~30mm excess on both sides, then cut the excess 

part with a special cutting knife on the joint center and trim the cut to make the turf join perfectly

together. After trimming, place the seam tape on the foundation surface and make the joint line of turf

right on the middle of the seam tape. And then apply the adhesive to seam tape evenly with a rubber

spreader, and press down the turf on both sides of the seam tape firmly;


5.1. Installing functional lines: 

Measure and re-position the functional line on the artificial turf tennis that has been all well joined on the ground. Cut theturf out and place the seam tape beneath the cuts, then spread the adhesive on the seam tape and  install the well-prepared functional lines, press it firmly to ensure the immobility.

5.2. Trimming: 

Inspect the finished high density artificial grass lawn, if any uneven found, cut it open, pull it straight and cut the excess away.

And rejoin it with adhesive;

6. Infilling sand of artificial turf roll: 

Place the sand piles on the finished lawn on different spots evenly at a distance of 4m from each other,

then spread them evenly on the lawn(the quantity if sand depends on the pile height of the turf). 

Afterwards, use the combing machine to sweep the sand into the fibers and to comb uo the fibers. Do

this process once longitudinally and transversely.


7. Infill rubber granules : 

After sand infilling, Place the rubber granules piles on the artificial turf roll  (sport artificial grass tennis)on different spots evenly at a distance

of 4m from each other, then spread them evenly on the lawn(sport artificial turf tennis  the quantity of sand depends on the pile

height of the turf). Afterwards, use the combing machine to sweep the sand into the fibers and to comb

up the fibers. Do this process once longitudinally and transversely.

8. Combing: 

Once the infilling is finished, comb the turf once more with the combing machie to make the fibers

point up to the sky.

9. Inspection:

Inspect the entire finished lawn as per concerned standards and requirement.If any defects found,

correct it.

QQ图片20171129150646.png

Related Products